My goal is to turn my water over once per day. If your original pump was a single speed then it would take 9 hours 30 minutes to turn your pool water over. I primarily use one program button on my pump and set it to run at 1800 GPH for 12 hours as that is the time it takes to turn mine over once (22,500 Gallons / 1800 GPH= 12.5 hours). You could program a button at 2750 and 12 hours run time to turn yours over once a day. There are some that run a mixed program like 3450 from 6 AM to 8 AM to get all the surface debris through to the skimmers first then a lower speed for the rest of the day to complete the daily turnover depending on pool size. I have another setting to run my robot off the same pump and turn a valve to have all the power go to that return...The quick clean is just a button on mine...push it and it runs at 3450 GPH for 2 hours. to backwash change valve position and run it at 3450 GPH you can use the arrow up and down buttons or the quick clean button then when backwash is done just stop it change the valve position back to filter and start filtering it again. Vaccum should use 3450 but valve position on filter if you are running a vaccum that connects to the skimmer

• Reply
• William S on Jul 21, 2016

I like to run mine from 6 AM to 6 PM.

• Reply
• William S on Jul 25, 2016