BEST ANSWER:The FLO error indicates the system does not detect any water flow while the primary pump is running. Check to make sure ALL water valves are open. (I would suggest closing and reopening the vales) Make sure the water level is correct and that the filters are clean. If the error continues, you will probably have to contact your dealer or service supplier.
BEST ANSWER:The FLO error indicates the system does not detect any water flow while the primary pump is running. Check to make sure ALL water valves are open. (I would suggest closing and reopening the vales) Make sure the water level is correct and that the filters are clean. If the error continues, you will probably have to contact your dealer or service supplier.
Turn off at the breaker and let it reset itself. This means the water didn't get through quickly enough and shuts off to prevent overheating the equipment. Check the pressure switch and make sure to turn it to allow water to move more quickly. Did you remember to open the valves after you refilled the tub?
May not be related but one time when I drained my spa and refilled it I forgot to turn off the power to the spa and it said FLO even though everything seemed fine. I just turned off the breaker and turned it back on and then it worked fine.
House was stuck by lighting had to replace home thermostat, modems, cable boxes etc . Also, no power to spa. Breaker was tripped, now breaker shows 220 amps . Replaced a 1/2 amp fuse in the spa pack, still no power and nothing showing on the control. Is there a reset button? Thank you!
BEST ANSWER:The FLO error indicates the system does not detect any water flow while the primary pump is running. Check to make sure ALL water valves are open. (I would suggest closing and reopening the vales) Make sure the water level is correct and that the filters are clean. If the error continues, you will probably have to contact your dealer or service supplier.
BEST ANSWER:The FLO error indicates the system does not detect any water flow while the primary pump is running. Check to make sure ALL water valves are open. (I would suggest closing and reopening the vales) Make sure the water level is correct and that the filters are clean. If the error continues, you will probably have to contact your dealer or service supplier.
Turn off at the breaker and let it reset itself. This means the water didn't get through quickly enough and shuts off to prevent overheating the equipment. Check the pressure switch and make sure to turn it to allow water to move more quickly. Did you remember to open the valves after you refilled the tub?
May not be related but one time when I drained my spa and refilled it I forgot to turn off the power to the spa and it said FLO even though everything seemed fine. I just turned off the breaker and turned it back on and then it worked fine.
House was stuck by lighting had to replace home thermostat, modems, cable boxes etc . Also, no power to spa. Breaker was tripped, now breaker shows 220 amps . Replaced a 1/2 amp fuse in the spa pack, still no power and nothing showing on the control. Is there a reset button? Thank you!
Phone Support (Central Time)
6am - 6pm Monday - Saturday
NEWSLETTER
ABOUT THE STORE Pool Supply Unlimited is an e-commerce company that loves water. We love to pump it, filter it, heat it, chlorinate it, light it up and stare at it while we're barbequing a fat, juicy steak. There are real pool professionals working here. Our guys have seen thousands of pools in their careers, no exaggeration. We are based in San Antonio, TX and can land most products to your door (within the 48 contiguous states) in less than a week.